Demonstration values modelled live from this simulation. On site they are read from the PLC.
Bench life at current hardener ratio: —. Strip time roughly 3× bench life at 25 °C sand. Raise sand temperature or hardener % to speed up; keep sand between 20 and 30 °C.
| Recipe | Binder system | Resin % sand | Hardener % resin | Sand t/h |
|---|
Loading a recipe writes its setpoints. While the mixer runs, the new values ramp in over 2 s. Edit any setpoint after loading and press Save to overwrite the selected recipe on this screen.
Run each pump into a tared bucket for 60 s at the test speed, weigh the catch and enter it. The HMI computes a correction factor and applies it to the flow output.
| Channel | Factor | Last set |
|---|
| Time | Severity | Message | State |
|---|
Shift A counters start from the example totals below. Simulation runs at 60× speed so a minute on the page equals an hour of mixing.
THRAEX CO & JEK · Built to run. Designed to grow. · +91 96626 46821 · thraex-globe.com
Simulated HMI for demonstration. Values are modelled, not read from a PLC.